intel core 2 duo 2.4 ghz e6600 amd equivalent

VESA driver.ĤGB RAM, Ubuntu 10.04 LTS, EIST off, C1E off, Spread Spectrum off, Disable Audio and network support, On-board video, Running GLXGEARS and reading PDFsĤGB Ram, Radeon HD 7350, Seagate Barracuda 1TB 7200rpm, Ubuntu 12.04.4 LTS, GRUB 1.99-21ubuntu3.14, 'isolcpus=1,2,3', with 'cpu hog' running, 3 GLXGEARS, surfing web, listening to music, system monitor running, and making this entry. VESA driver.ĪTI Radeon RV100 QY (VE/7000) AGP Card.

If you are going to use software stepping, then read this:ĤGB Ram, onboard display, 500gb SSD, LiveCD ?, 'isolcpus=2,3', with 'cpu hog' running, 2 GLXGEARS, disabled= Core performacnce boost, turbo performance boost, cool& quite, SVM Mode, C6 ModeĪTI 3D Rage IIC AGP Card. What can be done about improving latency? See these pages: Numbers over 1 millisecond (1,000,000 nanoseconds) mean the PC is not a good candidate for LinuxCNC, regardless of whether you use software stepping or not. If the numbers are 100 uS or more (100,000 nanoseconds), then the PC is not a good candidate for software stepping. If the Max Jitter is more like 30-50 microseconds, you can still get good results, but your maximum step rate might be a little disappointing, especially if you use microstepping or have very fine pitch leadscrews. So, what do the results mean? If your 'Max Jitter' number is less than about 15-20 microseconds (15000-20000 nanoseconds), the computer should give very nice results with software stepping.

If you want to add information to this page or add a new page, follow some BasicSteps. Results may vary by 1000 ns from one invocation to another (e.g., by a few microseconds). Note that the numbers reported in this test are extremely precise but not necessarily extremely reproducible. If you have a multi-cpu machine, it is helpful to report results with the isolcpus boot parameter set appropriately (see elsewhere in this wiki). Move around windows, surf the web, copy files, play music etc. Let the test run for at least 15 minutes (it has been suggested that the longer the better let it run for a day or overnight for instance) while you run glxgears or a similar application to stress the cpu. Latency-test comes with LinuxCNC, you can run it with 'latency-test' from the prompt.

Intel core 2 duo 2.4 ghz e6600 amd equivalent